Bonsoir,
Pour les anglophones, voici un email que m'avait envoyé le service technique de Gitzo lorsque je leur avait demandé comment entretenir/nettoyer mon trépied après quelques sorties sous des conditions météo un peu rude. Perso, je ne connaissais pas le WD-40 (je suis une brelle en mécanique) mais apparemment c'est un produit intéressant.
J'espère que ça pourra vous aider :
"Hello,
For routine cleaning, or whenever sand or water get inside the legs, you must disassemble the entire leg, simply by unscrewing each locking ring all the way. Remove all shims and bushings, and wipe the tubes down with some WD-40 on a soft rag. For sand, the insides of tubes must also be done. This can be done with a thin dowel and a rag wrapped around one end.
After it has air dried, only about 2-3 minutes, repeat process with rubbing alcohol. Use high-temp bearing grease to lube the threadings only. Do not lubricate the leg tubes. Reassemble and go."
-------------------
Mon site